Is there a simple .elf file we can use to reflash located?
When connecting the provided USB-C to Micro-USB cable from sharpikeebo board to rpi0 2W the entire board shuts down. In lieu of this, I directly soldered the D+ and D- pads to DP and DM pads and I still do not get keyboard
12/25/25
So I did some troubleshooting today. and here are my findings
- Connecting just the bare board to a computer it registers as a keyboard and works properly.
- D+ and D- pads do not connect to the header by the power switch
- If I connect the actual D+/D- to rpi0 DP/DM the keyboard shows up properly
- as stated before connecting the provided usb-c to usb micro cable from board rpi, the power module does wierd stuff and doesn't stay powered. most likely 5v getting shorted to gnd or some overcurrent issue. I modified a different cable to disconnect 5v/gnd and it works
- lastly the provided cable only works if: no battery, and rpi is directly powered.
Is there a simple .elf file we can use to reflash located?
When connecting the provided USB-C to Micro-USB cable from sharpikeebo board to rpi0 2W the entire board shuts down. In lieu of this, I directly soldered the D+ and D- pads to DP and DM pads and I still do not get keyboard
12/25/25
So I did some troubleshooting today. and here are my findings