This library is a port of the original Arduino compatible Dallas Sensor library. Some includes have been fixed, but the libary is otherwise untouched.
Note: This library depends on the OneWire library.
Original repository by Miles Burton: Arduino-Temperature-Control-Library.
This library supports the following devices :
- DS18B20
- DS18S20 - Please note there appears to be an issue with this series.
- DS1822
- DS1820
You will need a pull-up resistor of about 5 KOhm between the 1-Wire data line and your 5V power. If you are using the DS18B20, ground pins 1 and 3. The centre pin is the data line '1-wire'.